DYNACORD CL 1200
-
Code:CL 1200
-
Weight:15.000 Kgs
Power Amplifier 2x600W, Class-H Topology
Through the use of an optimized power supply with low dispersion toroidal transformers as well as of Class H technology, a large amount of headroom above the specified nominal output has been achieved along with a considerable reduction in weight and thermal leakage.
Specifications:
Load Impedance 2 Ohm, 4 Ohm, 8 Ohm
Max. Midband, Ohmutput Power, THD = 1%, 1kHz , Dual Channel 2 Ohm - 900W, 4 Ohm - 600W, 8 Ohm - 350W
Rated Ohmutput Power, THD < 0,1%, 20Hz … 20kHz 4 Ohm - 500W, 8 Ohm - 250W
Max. Single Channel, Ohmutput Power, Dynamic Headroom, IHF-A 2 Ohm - 1450W, 4 Ohm - 850W, 8 Ohm - 450W
Max. Single Channel, Ohmutput Power, Continuous, 1kHz 2 Ohm - 1200W, 4 Ohm - 720W, 8 Ohm - 410W
Max. Bridged, Ohmutput Power, THD = 1%, 1kHz 4 Ohm - 1800W, 8 Ohm - 1200W
Maximum RMS Voltage Swing, THD = 1%, 1kHz 62V
Power Bandwith, ref. 1kHz, THD =1%, half power @ 4 Ohmhms 10Hz … 60kHz
Voltage Gain, ref. 1kHz 32,0 dB
Input Sensitivity, at rated Ohmutput power +3,2 dBu (1,12 V rms)
THD at rated Ohmutput power, MBW = 80kHz, 1kHz < 0,05%
IMD-SMPTE, 60Hz, 7kHz < 0,02%
DIM 30, 3,15kHz, 15kHz < 0,01%
Maximum Input Level +22 dBu (9,76 V rms)
Crosstalk, ref. 1kHz, at rated Ohmutput power < -80 dB
Frequency Response, ref. 1kHz (- 1dB) 15Hz … 40kHz
Input Impedance, active balanced 20 kOhm
Damping Factor, 1kHz > 300
Slew Rate 30 V/µs
Signal to Noise Ratio, Amplifier, A-weighted 105,5 dB
Output Noise, A-weighted < -70 dB
Power Consumption 1/8 max., Ohmutput power @ 4 Ohmhms 500W (Measured with 110% Ohmf reated mains voltage)
Protections Audio limiters, High temperature, DC, HF, Back-EMF, Peak current limiters, Inrush current limiters, Turn Ohmn delay
Cooling Front-to rear, 3-stage fans
Dimensions (W x H x D) mm 483 x 88,1 x 386,8