DYNACORD CL 2000
-
Код:CL 2000
-
Тегло:19.000 кг
The new Compact Linear Precision Series power amplifiers combine outstanding audio performance with maximum reliability and operating security as well as being markedly lighter than equivalent power amplifiers.
Through the use of an optimized power supply with low dispersion toroidal transformers as well as of Class H technology, a large amount of headroom above the specified nominal output has been achieved along with a considerable reduction in weight and thermal leakage.
Specifications:
Load Impedance 2 Ohm, 4 Ohm, 8 Ohm
Max. Midband, Output Power, THD = 1%, 1kHz , Dual Channel 2 Ohm - 1500W, 4 Ohm - 1000W, 8 Ohm - 600W
Rated Output Power, THD < 0,1%, 20Hz … 20kHz 4 Ohm - 850W, 8 Ohm - 450W
Max. Single Channel, Output Power, Dynamic Headroom, IHF-A 2 Ohm - 2700W, 4 Ohm - 1450W, 8 Ohm - 750W
Max. Single Channel, Output Power, Continuous, 1kHz 2 Ohm - 1900W, 4 Ohm - 1150W, 8 Ohm - 650W
Max. Bridged, Output Power, THD = 1%, 1kHz 4 Ohm - 3000W, 8 Ohm - 2000W
Maximum RMS Voltage Swing, THD = 1%, 1kHz 80V
Power Bandwith, ref. 1kHz, THD =1%, half power @ 4 ohms 10Hz … 60kHz
Voltage Gain, ref. 1kHz 32,0 dB
Input Sensitivity, at rated output power +5,5 dBu (1,46 V rms)
THD at rated output power, MBW = 80kHz, 1kHz < 0,05%
IMD-SMPTE, 60Hz, 7kHz < 0,02%
DIM 30, 3,15kHz, 15kHz < 0,01%
Maximum Input Level +22 dBu (9,76 V rms)
Crosstalk, ref. 1kHz, at rated output power < -80 dB
Frequency Response, ref. 1kHz (- 1dB) 15Hz … 40kHz
Input Impedance, active balanced 20 kOhm
Damping Factor, 1kHz > 300
Slew Rate 35 V/µs
Signal to Noise Ratio, Amplifier, A-weighted 109,0 dB
Output Noise, A-weighted < -70 dB
Power Requirements 100V, 120V, 220V, 230V, 240 V; 50Hz … 60Hz (factory configured)
Power Consumption 1/8 max., output power @ 4 ohms 725W
Protections Audio limiters, High temperature, DC, HF, Back-EMF, Peak current limiters, Inrush current limiters, Turn on delay
Cooling Front-to rear, 3-stage fans
Dimensions (W x H x D) mm 483 x 88,1 x 386,8